Begin by removing the grip frame from the gun: 2 frame screws and the A.S.A. Carefully unplug the eye wires from the board along with the solenoid wires.
STEP THREE
Remove trigger guard and place off to the side along with the screws.
STEP TWO
Then, remove both trigger guard screws, both the top and the one in the battery.
STEP FIVE
Remove board and both buttons.
STEP FOUR
Use a center punch to drive the trigger pin out. Make sure you knock the pin from right to left.
STEP SEVEN
Remove both micro switch screws and switch.
STEP SIX
Unplug wires.
STEP NINE
Re-Install trigger guard.
STEP EIGHT
Install trigger by pushing pin in from left to right.
STEP ELEVEN
Put bottom hole of micro switch through switch plate pin, screw top micro switch screw in.
STEP TEN
Using a .050 Allen wrench, screw switch plate screw into bottom micro switch hole.
Shocktech Products
